Removing The Serveraid Adapter Memory Module - IBM x3550 M4 Type 7914 Installation And Service Manual

Results
Note: When you restart the server, you are prompted to import the existing RAID
configuration to the new ServeRAID adapter.

Removing the ServeRAID adapter memory module

Use this information to remove the ServeRAID adapter memory module.
About this task
To remove the ServeRAID adapter memory module, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see "Removing the cover" on page 36).
4. Remove the ServeRAID SAS/SATA controller (see "Removing a ServeRAID
5. Grasp the memory module and lift to remove it from the connector on the
Figure 157. ServeRAID memory module removal
Results
If you are instructed to return the memory module, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
260
IBM System x3550 M4 Type 7914: Installation and Service Guide
"Installation guidelines" on page 33.
SAS/SATA controller" on page 254).
ServeRAID adapter.