Table of Contents
Advertisement
Figure 16. System-board external connectors
System-board switches, jumpers, and buttons
The following illustration shows the location of the switches, jumpers, and buttons
on the server.
Important:
1. Before you change any switch settings or move any jumpers, turn off the
server; then, disconnect all power cords and external cables. Review the
information in "Safety" on page vii, "Installation guidelines" on page 33,
"Handling static-sensitive devices" on page 36, and "Turning off the server" on
page 24.
2. Any system-board switch or jumper block that is not shown in the illustrations
in this document are reserved.
3. If there is a clear protective sticker on the top of the switch blocks, you must
remove and discard it to access the switches.
Chapter 2. Installing optional devices
29
Advertisement
Chapters
Table of Contents
Troubleshooting
