IBM x3550 M4 Type 7914 Installation And Service Manual page 77

Figure 39. Adapter installation
Attention: When you install an adapter, make sure that the adapter is
correctly seated in the riser-card assembly and that the riser-card assembly is
securely seated in the riser-card connector on the system board before you turn
on the server. An incorrectly seated adapter might cause damage to the system
board, the riser-card assembly, or the adapter.
6. Install the PCI riser-card assembly in the server (see "Replacing a PCI riser-card
assembly" on page 245).
7. Connect the cable to the newly-installed adapter.
Note: You might need to remove the blue latch from PCI riser-card assembly 2
to easily connect the cables.
Figure 40. Latch removal
8. Perform any configuration tasks that are required for the adapter.
Results
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 96.
Chapter 2. Installing optional devices
59