IBM x3550 M4 Type 7914 Installation And Service Manual page 451

806f000f-22010bff Firmware BIOS (ROM) corruption was detected on system [ComputerSystemElementName]
during POST. (ABR Status)
Explanation: Firmware BIOS (ROM) corruption was detected on the system during POST.
May also be shown as 806f000f22010bff or 0x806f000f22010bff
Severity: Info
Alert Category: Critical - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0850
SNMP Trap ID: 40
Automatically notify Support: No
User response:
1. Make sure the server meets the minimum configuration to start (see Power-supply LEDs).
2. Recover the server firmware from the backup page: a. Restart the server. b. At the prompt, press F3 to recover
the firmware.
3. Update the server firmware to the latest level (see Updating the firmware). Important: Some cluster solutions
require specific code levels or coordinated code updates. If the device is part of a cluster solution, verify that the
latest level of code is supported for the cluster solution before you update the code.
4. Remove components one at a time, restarting the server each time, to see if the problem goes away.
5. If the problem remains, (trained service technician) replace the system board.
Firmware Error : Sys Boot Status :
806f000f-22010cff CPU voltage mismatch detected on [ProcessorElementName]. (ABR Status)
Explanation: This message is for the use case when an implementation has detected a CPU voltage mismatch with
the socket voltage.
May also be shown as 806f000f22010cff or 0x806f000f22010cff
Severity: Error
Alert Category: Critical - CPU
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0050
SNMP Trap ID: 40
Automatically notify Support: No
User response: This is a UEFI detected event. The UEFI(POST) error code for this event can be found in the logged
IMM message text. Please refer to the UEFI(POST) error code in the "UEFI(POST) error code" section of the Info
Center for the appropriate user response. Firmware Error : Sys Boot Status :
806f000f-22010bff • 806f000f-22010cff
Appendix A. Integrated management module II (IMM2) error messages
433