Figure 205. Video connector assembly screws removal
5. Pull the front video connector assembly out slightly until it disengages from the
Figure 206. Front video connector assembly removal
Replacing the front video connector assembly
Use this information to replace the front video connector assembly.
About this task
To install the front video connector assembly, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect the power cords and
3. Insert the front video connector assembly into the holes on the chassis.
Figure 207. Front video connector assembly installation
306
IBM System x3550 M4 Type 7914: Installation and Service Guide
chassis and set it aside.
"Installation guidelines" on page 33.
all external cables, if necessary.