Call-Manager Service Configuration; Http Server; Table 3-59 Configuring Http; Table 3-60 Verifying Http Configuration Settings - AddPac IPNext190 Installation Manual

IPNext 190 System Installation Guide

Call-Manager Service Configuration

http server

http server is enabled at default. If it is disabled, it should be enabled for configuring the settings of the IPNext
PBX, this command is to check the status of Call Manager and use Auto Upgrade Server.
Step
1
IP-PBX#
IP-PBX# configure terminal
IP-PBX(config)#
2
IP-PBX(config)# http server
3
IP-PBX(config)# no http authentication
4
IP-PBX(config)# http document-root /hd
Step
1
IP-PBX# show run
Building configuration...
Current configuration:
version 8.47.024
hostname IP-PBX!
interface FastEthernet0/0
Table 3-58 Configuring http
Command
Table 3-59 Verifying http Configuration Settings
Command
AddPac Technology Proprietary & Documentation
Description
Enter APOS command entry mode
Enable HTTP server. (default)
(Optional) Access to the server without
http authentication. http authentication
is recommended.
(Default: enable)
Configure the default directory for
accessing Web-based SMM (the default
setting for the version lower than
v8.47.024 is /hd)
*When you upgrade to higher version
than v8.47.024, change the setting of
http document–root to /hd (the default
setting for the version lower than
v8.47.024 is /hd/smartclient)
Description
Use show run command to verify http
configuration settings
132 - 80