Ftp Server; Table 3-47 Ftp Server Configuration; Table 3-48 Verifying Ftp Settings - AddPac IPNext190 Installation Manual

IPNext 190 System Installation Guide

ftp server

FTP is enabled at the default setting and it can be enabled when it is necessary. ftp server command is
enabled at TCP21.
FTP is disabled at the default setting and it can be enabled depending on its necessity. The ftp server
command enables ftp on the port number TCP21. Use ftp allow anonymous command to configure the open
ftp server. The user account for accessing ftp is configured by username command. The following example
enables ftp server and allowing access for the anonymous account.
Step
1 IP-PBX#
IP-PBX# configure terminal
IP-PBX(config)#
2 IP-PBX(config)# ftp server
IP-PBX(config)#
3
password router
4 IP-PBX(config)# ftp port 21
5 IP-PBX(config)#
anonymous
Step
1
IP-PBX# show run
Building configuration...
Current configuration:
version 8.47.024
hostname IP-PBX
!
interface FastEthernet0/0
ip address 172.20.101.100 255.255.0.0
!
ip route 0.0.0.0 0.0.0.0 172.20.1.1
!
ftp server
2
ideoPhone# show ip tcp port
Local Address / Port Remote Address / Port
Table 3-46 FTP Server Configuration
Command
username root
ftp allow
Table 3-47 Verifying FTP Settings
Command
AddPac Technology Proprietary & Documentation
Description
Enter APOS command entry mode
Enable FTP server
FTP user account. Create "root/router"
(Optional) Configure to change the default ftp port 21
(Optional) Allowing the anonymous account
Use show run command to verify the
enabled FTP setting details
Use show ip tcp port command to
verify the operational status of ftp port
Description
132 - 70