Voip-Interface; Table 3-34 Configuring Voip-Interface; Table 3-35 Verifying The Settings Of Voip-Interface - AddPac IPNext190 Installation Manual

Table of Contents

Advertisement

IPNext 190 System Installation Guide

voip-interface

This configuration specifies VoIP service to a specific interface. VoIP service is provided by using the IP address
specified to the VoIP interface, if the IP address is not specified to the VoIP interface, configuring the VoIP
settings and searching the content are not possible.
Step
1
IP-PBX#
IP-PBX# configure terminal
IP-PBX(config)#
2
IP-PBX(config)# voip-interface ip fastethernet
0/0 ?
Preference
<cr>
3
IP-PBX(config)# voip-interface ip fastethernet
0/0 preference 1
4
IP-PBX(config)#
fastethernet 0/0
Step
1
IP-PBX# show voip-interface
IP(Internet Protocol) VoIP Interface:
(*) voip-interface FastEthernet0/0 preference 1
link-up
voip-interface
link-down
IPv6(Internet Protocol version 6) VoIP Interface:
(*)
voip-interface
preference 1 link-up
!

Table 3-34 Configuring VoIP-Interface

Command
Set interface Preference
voip-interface

Table 3-35 Verifying the Settings of VoIP-Interface

Command
FastEthernet0/1
ipv6
AddPac Technology Proprietary & Documentation
Enter APOS command entry mode.
Specify
interface
As preference value<1-255>
lower, the priority gets higher.
Preference <1>
Configure
FastEthernet 0/0 (Default)
Configure
ipv6
FastEthernet 0/0 (Default)
Use
command to verify the settings
of voip-interface
preference
2
FastEthernet0/0
Description
IPv4
Interface
to
VoIP
gets
VoIP
service
to
IPv4
VoIP
service
to
IPv6
Description
show
voip-interface
132 - 62

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IPNext190 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents