Default Route; Table 3-28 Specifying Ipv4 Default Route; Table 3-29 Specifying Ipv6 Default Route; Table 3-30 Verifying Ipv4 Default Route - AddPac IPNext190 Installation Manual

IPNext 190 System Installation Guide

Default Route

To access a network in where a system is not configured, you should configure where to route.
In the same way to configure the default gateway from PC, configure the IP of the device which
has been connected already.
The following table presents an example to show configuring IPv4 to "172.20.1.1", IPv6 to
"2001:e78:b01:19:1::1"
Step
1
IP-PBX#
IP-PBX# configure terminal
IP-PBX(config)#
2
IP-PBX(config)# ip route 0 0 172.20.1.1
Step
1
IP-PBX#
IP-PBX# configure terminal
IP-PBX(config)#
2
IP-PBX(config)#
2001:e78:b01:19:1::1
Step
1
IP-PBX# show run
Building configuration...
Current configuration:
version 8.47.024
hostname IP-PBX
!
interface FastEthernet0/0
ip address 172.20.101.100 255.255.0.0
!
ip route 0.0.0.0 0.0.0.0 172.20.1.1

Table 3-28 Specifying IPv4 Default route

Command

Table 3-29 Specifying IPv6 Default route

Command
ipv6 route

Table 3-30 Verifying IPv4 Default route

Command
AddPac Technology Proprietary & Documentation
Description
Enter APOS configuration mode
Specify IPv4 default route to 172.20.1.1
Description
Enter APOS command entry mode
Specify IPv6
::/0
"2001:e78:b01:19:1::1"
Description
Use show run command to verify the
specified IPv4 default router
Default router to
132 - 60