Interface; Table 3-22 Configuring Fastethernet; Table 3-24 Configuring Ipv4 Interface - AddPac IPNext190 Installation Manual

IPNext 190 System Installation Guide

interface

For IPNext190 to communicate with other network devices, the IP Address must be configured.
The duplex and the bandwidth for connecting with other AddPac devices are set automatically
to the optimum value. However, the duplex for connecting with other vendor's devices may not
fit to each other, In this case, the bandwidth and duplex should be set manually.
The following example shows configuring the IP address of 172.20.101.100 to the interface of
Fastethernet 0/0 and then the link speed of 100Mbps and full duplex manually.
Step
1
IP-PBX#
IP-PBX# configure terminal
IP-PBX(config)#
2
IP-PBX(config)#
0/0
3
IP-PBX (config-if)#
172.20.101.100 255.255.0.0
4
IP-PBX (config-if)# no speed auto
5
IP-PBX (config-if)# speed 100
6
IP-PBX (config-if)# duplex full
Step
1
IP-PBX#
IP-PBX# configure terminal
IP-PBX(config)#
2
IP-PBX(config)# interface fastethernet 0/0
3
IP-PBX
2001:e78:b01:19:114::50/64
Step
1
IP-PBX# show run

Table 3-22 Configuring Fastethernet

Command
interface fastethernet
ip
3-23 Configuring IPv6 Interface
Command
(config-if)# ipv6

Table 3-24 Configuring IPv4 Interface

Command
AddPac Technology Proprietary & Documentation
Enter APOS configuration mode
Enter interface configuration mode
Configure the IP address of 172.20.101.100 to the
address
interface
If auto negotiation does not work, set to 100/full duplex
manually (Default: auto)
Enter APOS command entry mode
Enter interface configuration mode
Set
address
'2001:e78:b01:19:114::50/64' to the
interface
Use shown run command to verify the
Description
Description
the IPv6 address
Description
of
132 - 57