YOKOGAWA WT210 User Manual page 167

IM 760401-01E
10.4 Output Measured/Computed Data, Setup Parameters, and Error Codes
Each output block usually consists of five lines (six in case of recall) including the block
end line "END". However, if all output types on a line are set to "no output", this line will
be omitted, reducing the number of output lines by one. For example, if all output items
of ch.9 to ch12 are set to "no output", line 4 in the above example will be omitted.
Furthermore, if any channel on a line is set to "no output", all data following this
channel on the line will be shifted forward. For example, if the ch.2 on line 1 is set to
"no output", data of ch.1 will be followed by data of ch.3.
Output Format in case of Normal Measurement
• WT210 (760401)
Data
Line 1 Terminator
number
V1 data
Line 2 Terminator
Line 3 A1 data Terminator
W1 data Terminator
Line 4
Line 5
Frequency ,
Line 6 END Terminator
• WT230 (760502)
Data
Terminator
Line 1
number
V1 data ,
Line 2
Line 3
A1 data ,
W1 data ,
Line 4
Line 5 Frequency ,
Line 6 END Terminator
• WT230 (760503)
Data
Terminator
Line 1
number
V1 data ,
Line 2
Line 3
A1 data ,
W1 data ,
Line 4
Line 5 Frequency ,
Line 6
END Terminator
(The data number will only be output in case of recall)
Display C Terminator
(The data number will only be output in case of recall)
V3 data , SV data Terminator
A3 data SA data Terminator
,
,
W3 data SW data Terminator
Display C Terminator
(The data number will only be output in case of recall)
V2 data , V3data ,
A2 data , A3 data ,
W2 data , W3 data ,
Display C Terminator
SV data Terminator
SA data Terminator
SW data Terminator
10-7
10