YOKOGAWA WT210 User Manual page 14

Content
4.12
4.13
4.14
Chapter 5 Displaying Measurement Results and Computation Results
5.1
5.2
5.3
5.4
5.5
Chapter 6 Integration
6.1
6.2
6.3
6.4
Chapter 7 Harmonic Measurement Function (Option)
7.1
7.2
7.3
7.4
Chapter 8 Store/Recall Function of Measured/Computed Data and Setup
Parameters
8.1
8.2
Chapter 9 External In/Output Function
9.1
9.2
9.3
9.4
9.5
9.6
9.7
9.8
9.9
Chapter 10 GP-IB Interface (Option)
10.1
10.2
10.3
10.4
10.5
10.6
10.7
xii
Computing the Average Active Power during Integration ............................................... 4-29
Selecting the Number of Displayed Digits and the Display Update Rate ....................... 4-31
Selecting the Crest Factor ............................................................................................. 4-33
Displaying Voltage, Current and Active Power ................................................................. 5-1
Displaying Apparent Power, Reactive Power and Power Factor ..................................... 5-3
Displaying the Phase Angle ............................................................................................. 5-4
Displaying the Frequency ................................................................................................ 5-5
Displaying Efficiency (WT230 Only), Crest Factor, Four Arithmetic Operation Value,
Average Active Power, and Peak Value ........................................................................... 5-7
Integrator Functions ......................................................................................................... 6-1
Setting Integration Mode and Integration Timer ............................................................... 6-4
Displaying Integrated Values ........................................................................................... 6-6
Precautions Regarding Use of Integrator Function .......................................................... 6-9
Harmonic Measurement Function .................................................................................... 7-1
Setting the Target Element, PLL Source and Harmonic Distortion Method ..................... 7-4
Turning ON/OFF the Harmonic Measurement Function .................................................. 7-6
Setting the Harmonic Order and Displaying the Measured Harmonic Value ................... 7-7
Storing/Recalling Measured/Computed Data ................................................................... 8-1
Storing/Recalling Setup Parameters ................................................................................ 8-5
Pin Arrangement and Pin Assignments of the External I/O Connector (Option) .............. 9-1
Remote Control (Option) .................................................................................................. 9-3
D/A Output (Option) ......................................................................................................... 9-4
Comparator Function (Option) ......................................................................................... 9-9
Setting the Comparator Mode (Option) .......................................................................... 9-12
Setting the Comparator Limit Values (Option) ................................................................ 9-13
Comparator Display (Option) ......................................................................................... 9-17
Turning the Comparator Function ON/OFF (Option) ...................................................... 9-19
Outputting to an External Plotter or External Printer ...................................................... 9-20
GP-IB Interface Functions and Specifications ............................................................... 10-1
Responses to Interface Messages, and Remote/Local Modes ...................................... 10-3
Status Byte Format (before the IEEE 488.2 Standard) .................................................. 10-4
Output Format for Measured/Computed Data, Setup Parameters, and Error Codes .. 10-5
Setting the Address and Mode ..................................................................................... 10-11
Setting the Output Items .............................................................................................. 10-13
Commands (before the IEEE 488.2 Standard) ............................................................ 10-16
IM 760101-01E