Filtering Using The Web-Based Management Interface - Harmonic ProView 2900 Installation Manual

Chapter 7: Stream Configuration Menu

7.5.2. Filtering Using the Web-Based Management Interface

To use filtering mode through the front panel perform the following:
1. Configure ASI or/and IP outputs to filtering mode. To access the Service
submenus go to:
Stream General Output ASI Output Source After Filtering or
Stream General Output IP Output Source After Filtering
2. Set the following parameters at the Filtering sub menu: Strategy, Mode, Bit-rate
mode and Bit-rate value. To access the Filtering submenu go to:
Stream
Figure 7-3 shows the corresponding Filtering Web-Management screen.
3. In case the service filtering strategy is selected, set the services (see section
7.5.4). To access the Select Services submenu go to:
Stream
4. In case the PID filtering strategy is select, set the PIDs (see section 7.5.5).
To access the Select PIDs submenu go to: Stream
© Harmonic Inc. Manual p/n 101543/Ver 1.0
Filtering
Figure 7-3: Filtering Parameters web-management screen
Select Services
7-11 ProView 2900 Series/SW Version 1.94
Stream Filtering Configuration
Select PIDs