Chapter 14: Unit Configuration Menu
14.8.14. Dry Contact Configuration Using the Web-Interface
Configuring the dry contact in the Web interface is divided to two different menus:
Alarms – Allows enabling and disabling the alarms.
•
GPI – Allows setting the GPI delay time and tests.
•
To access the Dry Contact (Alarms) configurations though the web-interface, go to:
Unit Alarms. Figure 14-9 displays the Alarms web-interface screen:
NOTE
GPI1, GPI2, and the SNMP alarm can be enabled or disabled for every alarm. However once
the Alarm Mask is disabled then also GPI1 and GPI2 are disabled.
To access the Dry Contact (General) configurations though the web-interface, go to:
Unit GPI. Figure 14-10 displays the GPI web-interface screen:
© Harmonic Inc. Manual p/n 101543/Ver 1.0
Figure 14-9:
Alarms Web-Interface Screen
Figure 14-10:
GPI Web-Interface Screen
14-15
Dry Contact Menu
ProView 2900 Series/SW Version 1.94