General - Harmonic ProView 2900 Installation Manual

Chapter 6: Receiver Configuration Modules
FEC (Forward Error Correction)
6.3.1.3.
The ProView 2900 IP Front End-FEC Implementation complies with ProMPEG CoP3v2, with
the following limitations:
Columns support only
Maximum TS bit-rate - 20 Mbps
1 FEC Column Port 1 FEC Column Port 1 FEC Column Port 1 FEC Column Port
Selecting FEC Column Port displays the following screen, which allows setting the UDP port
number carrying the FEC data.
02002 02002 02002 02002
< 00000 < 00000 – – – – 65535 > < 00000 < 00000
Available values range from 0 to 65535.
NOTE
The default FEC Column port is set to N+2, where N is the value of the UDP Destination port.

6.3.2. General

The IP Receiver General Configuration screen allows the user to set several parameters:
1 Selected Active Port 1 Selected Active Port 1 Selected Active Port 1 Selected Active Port
2 Redundancy 2 Redundancy
2 Redundancy 2 Redundancy
3 Redundancy Delay 3 Redundancy Delay 3 Redundancy Delay 3 Redundancy Delay
4 De- - - - Jitter Delay 4 De
4 De 4 De
5 FEC 5 FEC 5 FEC 5 FEC
Figure 6-7 displays the corresponding DVB-IP Receiver General Parameters Menu (Web
Management screen).
© Harmonic Inc. Manual p/n 101543/Ver 1.0
FEC FEC FEC FEC
FEC Column Port FEC Column Port FEC Column Port FEC Column Port
65535 > 65535 > 65535 >
General General
General General
Jitter Delay
Jitter Delay Jitter Delay
6-32 ProView 2900 Series/SW Version 1.94
IP Receiver Configuration
1 1 1 1 - - - - 2 2 2 2 - - - - 1 1 1 1 - - - - 1 1 1 1 - - - - 3 3 3 3
02002 02002 02002 02002
1 1 1 1 - - - - 2 2 2 2 - - - - 1 1 1 1 - - - - 3 3 3 3
01 01 01 01
DISABLE DISABLE
DISABLE DISABLE
005 [Sec] 005 [Sec] 005 [Sec] 005 [Sec]
0100 [mSec] 0100 [mSec]
0100 [mSec] 0100 [mSec]
DISABLE DISABLE DISABLE DISABLE