Harmonic ProView 2900 Installation Manual page 141

Chapter 8: Service Configuration Menu
To access the Service Configuration menu in the front panel control interface go to
Configuration Service.
The following screen displays the Service configuration menu from the ProView 2900 Front
Panel:
1 TV1 Select 1 TV1 Select 1 TV1 Select 1 TV1 Select
2 TV2 Select 2 TV2 Select
2 TV2 Select 2 TV2 Select
3 Stand 3 Stand- - - - Alone Select 3 Stand 3 Stand
4 Preferred Language 4 Preferred Language 4 Preferred Language 4 Preferred Language
5 PID Select 5 PID Select 5 PID Select 5 PID Select
6 Mapping Port to Service 6 Mapping Port to Service
6 Mapping Port to Service 6 Mapping Port to Service
7 General Configuration 7 General Config 7 General Config 7 General Config
Figure 8-2 displays the corresponding Service Configuration Menu structure in the
ProView 2900 Web Management.
Figure 8-2:
The Service Configuration menu provides access the the following parameters:
TV1 (and TV2 Select, if applicable)
•
Enables assign a service from the incoming TS to a decoder. In the case of a dual
decoder, a user can assign two services from the incoming TS, one for each decoder
(see Section 8.2).
Stand-Alone Select
•
This feature will be supported in the future software releases.
Preferred Language
•
This group contains parameters that define the preferred language (see Section 8.4).
© Harmonic Inc. Manual p/n 101543/Ver 1.0
Service Service
Service Service
Alone Select Alone Select Alone Select
uration+ + + + uration uration
Web Manager Service Configuration Menu Screen
8-2
Service Configuration Menu Tree
1 1 1 1 - - - - 2 2 2 2 - - - - 3 3 3 3
ProView 2900 Series/SW Version 1.94