Applying The Slicing - Maschine mikro User Manual

Parameter
START
END
F2 and F3
ADD (F2)
REMOVE (F3)
After you have performed your Slice edits, confirm them by pressing
►
leave Slice Edit mode
14.4.4

Applying the Slicing

Once you are satisfied with the proposed and/or manually adjusted Slices (see section
↑14.4.2, Adjusting the Slicing
original Sample and create these Slices. This is done via the three elements at the bottom
right of the Slice page:
Description
Adjusts the start point of the selected Slice. If the start point of the Slice and
the end point of the previous Slice are still joined, moving the start point of the
Slice simultaneously moves the end point of the previous Slice, so that both Sli-
ces stay joined.
Adjusts the end point of the selected Slice. Note that moving the end point of a
Slice does not simultaneously move the start point of the next Slice — in opposi-
tion to adjusting the START parameter (see above).
Adds another Slice according to the current slicing settings.
Removes the start border of the selected Slice, thereby joining this Slice with
the previous Slice.
(EDIT turns off).
Settings), you can apply the slicing in order to actually cut the
Sampling and Sample Mapping
Slicing a Sample
F1 (EDIT) again to
MASCHINE MIKRO - Manual - 636