Location And Name Of Your Recorded Samples; Editing A Sample - Maschine mikro User Manual

▪ The selected recording is automatically loaded in the Sampler Plug-in and ready to be
played. You can further edit the selected recording via the other pages of the Sampling
mode. When selected, a recording is also automatically mapped to a new Zone covering
the entire key and velocity ranges in the
▪ Press the fully lit pad to listen to the displayed recording on the Cue bus (see section
↑9.2.6, Using the Cue Bus
▪ Press SHIFT + F3
The Recording History is not saved with the Project! The Recording History is meant as a
temporary tool to help you manage the various recordings made during the current session.
When you close the current Project, the Recording History is cleared for all Sounds — nev-
ertheless all your recordings are saved as audio files and available for later use unless you
explicitly delete them (via the MASCHINE interface or in your operating system).
14.2.5

Location and Name of Your Recorded Samples

By default, recorded Samples are saved in the Recordings subfolder of your Standard User Di-
rectory, as defined on the
Preferences – Default
page of the Preferences
be saved instead in a Recordings subfolder of the folder where your current Project is saved.
Recorded Samples are automatically named using the following scheme:
[YYMMDD]T[HHMMSS].wav
In the name above, [YYMMDD] stands for the current date (year, month, day, all 2-digit num-
bers) and [HHMMSS] for the current time (hours, minutes, seconds, all 2-digit numbers).
14.3

Editing a Sample

The Edit page of the Sample Editor in the software and its equivalent the
pling mode on your controller allow you to adjust the start and end points of a Sample or Slice
and to apply various destructive audio processing functions to any part of the Sample.
ZONE
for more information).
(DELETE) to delete the selected recording.
User pane of the Library
Page). If you activate the
panel (see ↑2.5.1, Preferences – General
page. Any existing Zones will be replaced.
page in the Preferences
Prefer Project Folder option on the
Page), recorded Samples will
MASCHINE MIKRO - Manual - 611
Sampling and Sample Mapping
Recording a Sample
panel (see
↑2.5.2,
General
EDIT page of the Sam-