Maschine mikro User Manual page 631

Parameter
SLICES (Split and Grid
mode only)
SENSITIVITY (Detect mode
only)
BPM (BPM Mode)
ADJUST
When MODE is set to DETECT, a second section of parameters is available at the bottom of the
display: the ENGINE section.
When MODE is set to DETECT, press
►
tion.
The ENGINE section.
This ENGINE section contains a single parameter: ZERO-X.
Description
When MODE is set to SPLIT (see above),
ces: 4, 8, 16 or 32.
When MODE is set to GRID (see above),
ces in note values: 4th, 8th,16th or 32nd notes.
When MODE is set to DETECT
of the transient detection. Higher values will cause more Slices to be detected
because more transients will be recognized, lower values will result in less Sli-
ces. This parameter should be adjusted until all the musically significant slices
are being detected in the waveform.
Selects how the tempo is defined: If you select AUTO, MASCHINE will calculate
the tempo automatically. If you select MANUAL, you can enter the tempo in BPM
manually.
If BPM is set to AUTO, you can choose between the tempo that MASCHINE detec-
ted, or half or double of that tempo. If
tempo manually.
NAV + the Right Arrow button to show the
SLICES lets you choose the amount of Sli-
SLICES lets you choose the length of the Sli-
(see above), SENSITIVITY lets you adjust the sensitivity
BPM is set to MANUAL, you can adjust the
Sampling and Sample Mapping
Slicing a Sample
ENGINE sec-
MASCHINE MIKRO - Manual - 631