Maschine mikro User Manual page 183

The Note Repeat mode on the controller.
In Note Repeat mode you can customize the way your Sounds/notes will be repeated by adjust-
ing following settings:
Element
F1–F3
GATE
RATE
TYPE
Description
Select between three different presets — also while playing. The rate currently
assigned to each button is indicated below on the display. The selected rate is
highlighted. You can change the rate and rhythm assigned to each button by se-
lecting it and adjusting the
Adjusts the ratio between the duration of the notes and the duration of the silen-
ces between them, measured as a percentage of the note value set by
above). Available values range from
short. At 50 % notes and silences are equal. At
exactly until the next note is triggered. At higher values notes overlap (provided
that the selected Sound is polyphonic). This setting applies globally to all rate
presets.
Adjusts the rate assigned to the selected
BAR and a series of note values going from
twenty-eighth note).
Selects from three variations of the original note length defined by the
rameter: NORMAL plays the original note length (default setting),
lets of the original note length (faster, three notes in the duration of two original
notes), and DOTTED plays dotted versions of the original note length (slower, two
notes in the duration of three original notes). Under the
values are indicated by a "T" and dotted values by a "D" next to the note value.
RATE and TYPE parameters (see below).
0 % to 200 %: At low values the notes are very
100 % (midcourse) each note lasts
F1–F3 button. Available values are
1/2 (half note) until
MASCHINE MIKRO - Manual - 183
Playing on Your Controller
Playing Tools
RATE (see
1
1/128 (a hundred
RATE pa-
TRIPLET plays trip-
F1–F3 buttons, triplet