Maschine mikro User Manual page 136

Selecting Sounds and Groups via the Select mode.
You have following selection tools at your disposal:
Selection Tool
Pads
GROUP then pads
Left/Right Arrow buttons
(< BANK >)
F3 (MULTI)
The MULTI option (F3) switches between single and multiple selection:
▪ When MULTI is disabled
◦ Pressing GROUP
lected Sound, sets the focus to that Group/Sound and clears the current Group/Sound
selection (only the focused Group/Sound is then selected). The pad lights up.
◦ Pressing GROUP
Sound, sets the focus to that Group/Sound without changing the current Group/Sound
selection. The pad stays fully lit.
▪ When MULTI is enabled
Description
Press any pad to set the focus to that particular Sound slot. The pad lights up to
indicate that the Sound slot is focused (and selected). Unlit pads indicate unse-
lected, empty Sound slots, and half-lit pads indicate unselected Sounds. The se-
lection behavior depends on the state of the
Press GROUP, then any pad
current Group bank. The pad lights up to indicate that the Group is focused (and
selected). Unlit pads 9–16
ing Group), and half-lit pads indicate unselected Groups. The selection behavior
depends on the state of the
Selects the previous/next Group bank, respectively.
Enables/disables the multiple selection mode. Toggling this button does nothing to
the current focus nor selection but changes the behavior of the selection process
— see below.
(F3 off):
then the pad of an unselected Group, or pressing the pad of an unse-
then the pad of a selected Group, or pressing the pad of a selected
(F3 on):
Managing Sounds, Groups, and Your Project
MULTI option (F3, see below).
9–16 to set the focus to that particular Group in the
cannot be pressed (they don't correspond to any exist-
MULTI option (F3, see below).
Overview of the Sounds, Groups, and Master
MASCHINE MIKRO - Manual - 136