Maschine mikro User Manual page 559

Example with playback on: Assuming that the Pattern Grid resolution is set to one bar, if you
click around the 8.3 mark (3rd beat of the 8th bar) in the timeline when the playhead reaches
the 3.2 mark (2nd beat of the 3rd bar), the playhead will jump from the
(2nd beat of the 8th bar) and continue from there.
You can also change the playback position by switching to another Scene. The moment at
which the jump will occur depends on the Perform Grid setting. See section
Jumping to Other Scenes
13.1.4.1 Controlling the Playback Position in Your Project from Your Controller
From your controller, you can control the playback position in two different resolutions.
Jumps Based on the Pattern Grid
Press the Locate buttons (showing left/right arrows) in the
►
to the previous/next Pattern Grid division.
Depending on the playback state, the following will happen:
→
▪ If playback is off, the playhead jumps to the beginning of the previous/next Pattern Grid
division.
▪ If playback is on, the playhead jumps to the same relative position in the previous/next
Pattern Grid division. This allows seamless jumps that don't break the rhythm of your mu-
sic.
If the Pattern Grid is set to
For more information on the Pattern Grid, see section
and the Pattern
Jumps Based on the Step Grid
You can also jump by finer increments:
Hold SHIFT and press the Locate buttons (showing left/right arrows) in the
►
section to jump to the previous/next step, according to the current Step Grid settings.
Depending on the playback state, the following will happen:
→
for more information.
OFF (i.e. disabled) or QUICK, the jumps are based on bars.
Length.
Creating a Song Using Scenes
3.2 to the
↑13.3.2,
TRANSPORT section to jump
↑7.1.6, Adjusting the Pattern Grid
TRANSPORT
MASCHINE MIKRO - Manual - 559
Arranger Basics
8.2 mark