Maschine mikro User Manual page 332

The AUDIO page of the Output properties (here for a Sound) on the controller.
Please refer to section
ges in the Control Area
the software and from your controller.
Controls
AUDIO Section
Dest.
Cue
Level
↑2.3.3, Navigating Channel Properties, Plug-ins, and Parameter Pa-
to know how to access the
Description
Select where you want to send the main audio output of your channel.
For Sounds, the available options are None (no output), Master, Group (parent
Group, default setting), any other Group or any other Sound acting as bussing
point (i.e. containing an Effect Plug-in in its first Plug-in slot), as well as the
16 external stereo outputs Ext. 1–16.
For Groups, the available options are None (no output), Master (default set-
ting), any other Group acting as bussing point (i.e. containing an Effect Plug-in
in its first Plug-in slot), any Sound acting as bussing point in any other Group,
as well as the 16 external stereo outputs Ext. 1–16.
The available bussing points are labeled as described below.
When Cue is enabled, the main output of the channel is sent to the Cue bus
instead of its normal target (defined in Dest., see above). For example, this is
very useful when you want to pre-listen to a channel before you mix it in your
performance. See also section
Note that when Cue is enabled, the channel's Aux 1 and Aux 2 outputs are
muted as well — but they are not sent to the Cue bus (see
Auxiliary Outputs for Sounds and Groups
Adjust the overall volume level of the channel.
Audio Routing, Remote Control, and Macro Controls
Audio page of the Output properties in
↑9.2.6, Using the Cue Bus
below).
MASCHINE MIKRO - Manual - 332
Audio Routing in MASCHINE
for more information.
↑8.1.3, Setting Up