Maschine mikro User Manual page 355

▪ In order to be automatable, a parameter must be controlled by a knob or a button in the
software — most parameters controlled by selectors (e.g., for selecting an operating mode
or a filter type) cannot be automated.
Almost all parameters meeting this requirement are automatable, the only exceptions being:
▪ Plug-ins:
◦ Saturator: in Tube mode, the
(EQ section).
◦ Percussion (Drumsynth): in Fractal mode, the
▪ Channel properties:
◦ Sound's and Group's Output properties: the
◦ Group's Input properties: the
◦ Master's Groove properties: the
At the Sound and Group level the same parameters can be both automated and modulated.
For more information on modulation please refer to section
Modulation.
Also note that your Macro Controls will be automatable if, and only if, the parameters they are
controlling are themselves automatable. For more information on Macro Controls please refer to
section ↑8.3, Creating Custom Sets of Parameters with the Macro
Assigning Host Automation IDs to Parameters (MASCHINE as Plug-in)
1. Click the down-pointing arrow in the bottom left corner of the Control area to open the
Assignment area underneath.
Bass Overload button (MAIN
Tune Hold
Cue button in the
Root Note knob in the MIDI
Amount knob and Invert
Audio Routing, Remote Control, and Macro Controls
Using MIDI Control and Host Automation
section) and Bypass
button in the Main page.
Audio page.
page.
toggle in the Swing page.
↑7.5, Recording and Editing
Controls.
MASCHINE MIKRO - Manual - 355
button