Table of Contents
Advertisement
REPLACEMENT AND ADJUSTMENTS OF PARTS
3-4. Lower Chute Assembly
(1)
Remove the following units:
• Gear double L (according to the procedure
described in section 3-2)
• Gear double R (according to the procedure
described in section 3-3)
(2)
Lower the lower chute assembly [1] towards the back
of the unit, and, pressing the bottom plate assembly
[2] against the cam [4] of the pick up roll assembly
[3], rotate the pick up roll assembly [3] until the
bottom plate assembly [2] is at the position closest to
the front of the unit.
Remove the spring [6] from the screw [5]. The spring
(3)
[6] is hooked onto the screw [5] that projects from
bottom plate assembly [2].
(4)
Remove the following units:
• Two stop rings [7]
• Lower chute assembly [1]
Slide the left pivot shaft [8] 25 mm to the left, and
the right pivot shaft [9] 25 mm to the right to
remove the lower chute assembly [1].
Caution when disassembling:
Do not remove the two pivot shafts [8] and [9] from the gear
front cover and front cover assembly [10].
Caution when assembling:
Attach the stop ring [7] on the left pivot shaft [8] to the
groove on the inner side, and the stop ring [7] of the right
pivot shaft [9] to the groove on the outer side.
3-5. Take Away Roll Assembly
(1)
Open the front cover assembly [1].
Remove the take away roll assembly [2] from the
(2)
lower chute [3].
Caution when assembling:
• Line up the positioning boss [4] of the take away roll
assembly [2] with the groove [5] for positioning the
lower chute [3], and install the take away roll assembly
[2].
• Be careful not to let the mylar on the lower chute [3] get
caught up in the other parts. When the front cover
assembly [1] is open, the mylar should be attached on
the underside of the take away roll assembly [2].
– 33 –
Advertisement
Chapters
Table of Contents
