Feed Roll Assembly; Feed Rolls - Star Micronics LS-5 SERIES Technical Manual

REPLACEMENT AND ADJUSTMENTS OF PARTS

2-3. Feed Roll Assembly

(1) Remove the following units:
• Feed housing R, gear in, and gear out (according
to the procedure described in section 2-2)
• Two screws [1]
• Three screws [2]
• Feed housing L [3]
• Stop ring [4]
• Feed bearing [5]
• Feed roll assembly [6]

2-4. Feed Rolls

(1) Remove the following units:
• Feeder assembly (according to the procedure
described in section 2-1)
• Four feed rolls [1]
Supporting the shaft [2] of the feed roll assembly,
press on the plastic surface of the feed roll [1] and
remove the feed roll [1] from the shaft [2] of the
feed roll assembly.
Caution when assembling:
Line up the feed roll [1] with the positioning hole in the
shaft [2] of the feed roll assembly.
– 28 –