REPLACEMENT AND ADJUSTMENTS OF PARTS
2-5. Turn Roll Assembly
(1)
Remove the following units:
• Feed housing R, gear in, and gear out (according
to the procedure described in section 2-2)
• Stop ring [1]
• Feed bearing [2]
• Turn roll assembly [3]
2-6. No Paper Actuator
(1)
Remove the following units:
• Feed housing R, gear in, and gear out (according
to the procedure described in section 2-2)
• No paper actuator [1]
Bend the no paper actuator [1] and force it past the
projection [2] on the feeder frame assembly.
Remove the no paper actuator [1] with the detect-
ing section [3] in the upward position.
– 29 –