Btr Assembly; Trans. Chute Assembly - Star Micronics LS-5 SERIES Technical Manual

REPLACEMENT AND ADJUSTMENTS OF PARTS

3-7. BTR Assembly

(1) Open the front cover [1].
(2) Pull the BTR assembly [2] off the trans. chute
assembly [3], and remove it.
Caution when disassembling:
Be careful not to touch the BTR surface of the BTR
assembly [2], or the eliminator of the trans. chute assembly
[3]. While restraining the trans. chute assembly [3], pull out
the BTR assembly [2].
After the BTR assembly [2] has been drawn out, wrap it
carefully in paper to keep it from becoming dirty or
damaged, and store it in a safe place.
Assembly:
(1) Remove the trans. chute assembly [3] according to
the procedure described in section 3-8.
Line up the bearing [4] of the trans. chute assembly
(2)
[3] with the shaft of the BTR assembly [2]. Install the
BTR assembly [2] so that its gear is on the left side.
Restraining the left end of the BTR assembly [2]
(3)
shaft, press the right end into position, and attach the
BTR assembly [2] to the bearing [4] of the trans.
chute assembly [3].
(4) Fit the tip of the mini-screwdriver under the bearing
[4] of the left trans. chute assembly [3], and, while
pressing on the left end of the BTR assembly [2]
shaft, attach the BTR assembly [2] to the bearing [4]
of the left trans. chute assembly [3].
Install the trans. chute assembly [3] according to the
(5)
procedure described in section 3-8.

3-8. Trans. Chute Assembly

Open the front cover assembly [1].
(1)
(2) Remove the following units:
• BTR assembly [2] (according to the procedure
described in section 3-7)
• Two screws [3]
• Trans. chute assembly [4]
Hold down the front cover while removing the
trans. chute assembly.
• Connector (P/J TR-T)
• Screw securing the wire assembly eliminator
Caution when assembling:
After attaching the BTR assembly [2], reverse the assembly
procedure to disassemble it.
– 35 –