Exit Chute; Exit Roll Assembly - Star Micronics LS-5 SERIES Technical Manual

REPLACEMENT AND ADJUSTMENTS OF PARTS

4-3. Exit Chute

(1) Remove the following units:
• Pressure roll (according to the procedure
described in section 4-2)
• Two screws [1]
• Two exit springs [2]
• Exit chute [3]
Caution when assembling:
When removing the exit chute [3], be careful not to scratch
the heat roller [4].
Caution when disassembling:
Insert the exit actuator [6] in the notch of the exit chute [3],
and attach the exit chute [3].

4-4. Exit Roll Assembly

(1) Remove the following units:
• Exit chute (according to the procedure described
in section 4-3)
• Two stop rings [1]
• Gear exit [2]
• Exit roll assembly [3]
– 42 –