3-17. Faulty Drive Assy
Step
1
Check parts with different specifications for problems with
usage, defective installation, breakage, deformation, and adhe-
sion of grime or foreign matter.
• Main parts to be checked:
(1) Drive assy, (2) MCU PCB, (3) LVPS assy
(4) Feeder assy, (5) Optional feeder unit
(6) Take away roll assy, (7) EPX toner cartridge
(8) Fuser assy
2
(Check drive assy) *1
Does the drive assy rotate smoothly when the hand crank is used?
3
(Check power supply of main motor) *2
Is 24 VDC being supplied between P/J14-1PIN
2PIN, and between P/J14-2PIN
4
(Check main motor)
Is there conductivity (approximately 5Ω) between the following?
↔
J14-1PIN
↔
J14-1PIN
↔
J14-2PIN
↔
J14-2PIN
5
(Check replacement of MCU PCB)
Does the problem occur after the MCU PCB has been replaced
with a normal one?
6
(Check optional feeder unit) *1
Remove the optional feeder unit and see if the drive assy rotates
smoothly when the hand crank is used.
7
(Check feeder assy) *1
Remove the feeder assy and see if the drive assy rotates
smoothly when the hand crank is used.
8
(Check take away roll assy) *1
Remove the take away roll assy and see if the drive assy rotates
smoothly when the hand crank is used.
9
(Check EPX toner cartridge) *1
Remove the EPX toner cartridge and see if the drive assy
rotates smoothly when the hand crank is used.
10
(Check fuser assy) *1
Remove the fuser assy and see if the drive assy rotates smoothly
when the hand crank is used.
*1: The direction of rotation for the gears attached to the main motor is in the counterclockwise direction when the
machine is viewed from the right.
Note: Never rotate the gears attached to the main motor in the clockwise direction as viewed from the right side of the
machine.
*2: Check with the connector (P/J111) disconnected from the HVPS.
Check
↔
P/J11-2PIN?
J14-3PIN
J14-5PIN
J14-4PIN
J14-6PIN
To step 2
To step 3
To step 4
↔
P/J11-
To step 5
Replace drive
assy.
To step 7
To step 8
To step 9
To step 10
Replace drive
assy.
– 111 –
TROUBLESHOOTING
Measure
YES
NO
Replace or
reinstall.
To step 6
To section 3-1
Replace drive
assy.
Processing
completed.
Replace optional
feeder unit.
Replace feeder
assy.
Replace away roll
assy.
Replace EPX
toner cartridge.
Replace fuser
assy.