Ess Assembly; Main Logic Board - Star Micronics LS-5 SERIES Technical Manual

REPLACEMENT AND ADJUSTMENTS OF PARTS

5-5. ESS Assembly

(1) Remove the following units:
• Left cover and right cover (according to the
procedure described in section 1-3)
• Connector (P/J5) [1] of the main logic board
• Ten screws [2]
• ESS assembly [3]
Note: When the ESS assembly [3] is lifted up, the
connector (P31) comes off.

5-6. Main Logic Board

(1) Remove the following units:
• ESS assembly (according to the procedure
described in section 5-5)
• Two connector covers [1]
• Connector cover
• Blind plate
• Three screws [2]
• Extra rear panel [3]
• RAM board (if installed)
• ROM board MS (if installed)
• Four screws [4]
• Two screws [5]
• ESS rear panel [6]
• Five screws [7]
• Main logic board [8]
• Transit BD RAM unit [9]
• Transit BD PDL unit [10] (for LS-5EX and LS-
5TT)
– 47 –
(for LS-5EX and LS-5TT)
1a
1b
(for LS-5)