Pick Up Solenoid; Mbf Sensor Assembly - Star Micronics LS-5 SERIES Technical Manual

REPLACEMENT AND ADJUSTMENTS OF PARTS

3-13. Pick Up Solenoid

(1) Remove the following units:
• Electrical box cover (according to the procedure
described in section 5-7)
• Connector (P/J17) on the MCU PCB
• Trans. chute assembly (according to the proce-
dure described in section 3-8)
• Inlet chute assembly (according to the procedure
described in section 3-9)
• Front plate assembly (according to the procedure
described in section 3-11)
• Pick up roll assembly (according to the procedure
described in section 3-12)
• Connector (P/J 301)
• Screw [2]
• Pick up solenoid [3]
Caution when disassembling:
Confirm the routing of the harness before removing the
pick up solenoid [3].

3-14. MBF Sensor Assembly

(1) Remove the following units:
• Pick up roll assembly (according to the procedure
described in section 3-12)
• MBF spring [1]
• Two screws [2]
• Connector (P/J121) [3]
• MBF sensor assembly [4]
Caution when assembling:
Be careful of the attachment position for the MBF spring
[1].
– 38 –