Heat Roll; Exit Actuator; Exit Sensor - Star Micronics LS-5 SERIES Technical Manual

REPLACEMENT AND ADJUSTMENTS OF PARTS

4-7. Heat Roll

(1) Remove the following units:
• Exit chute (according to the procedure described
in section 4-3)
• Two screws [1]
• Fuser inlet chute [2]
• Heater rod (according to the procedure described
in section 4-6)
• H/R ring [3]
• Gear H/R [4]
• H/R bearing R[5]
• Screw [6]
• Ground plate [7]
• H/R ring [8]
• H/R bearing L [9]
• Heat roll [10]

4-8. Exit Actuator

(1) Remove the following units:
• Heat roll (according to the procedure described in
section 4-7)
• Exit actuator [1]
• Exit torsion spring [2]

4-9. Exit Sensor

(1) Remove the following units:
• Fuser assembly (according to the procedure
described in section 4-1)
• Connector (P/J119) [1]
• Exit sensor [2]
– 44 –