Table of Contents
Advertisement
GENERAL SPECIFICATIONS
10. Carriage Motor Assy
11. Carriage Unit
(1)
Remove
Rear case unit as described in section 2.
Screw [1]
Spring [2]
Set tension lever assy [3] in the unlocked position.
Two screws [4]
Carriage motor unit [5]
Note:
When assembling the carriage motor assy, the
tension lever assy [3] must be secured with the
screw [1] when the spring [2] is in place.
(1)
Remove
Ribbon holder as described in section 3.
Print head as described in section 8.
Head cable [1]
Ground spring [2]
Stop ring [3]
Adjusting gear [4]
Adjusting bushings L, R [5] [6]
Adjusting bushings L/R can be removed by turn-
ing them.
Carriage unit [7]
Center the carriage unit.
Note:
Move the carriage unit to the center position, then
align the " " mark of adjusting gear [4] with the
" " mark of adjusting lever [8].
– 40 –
Advertisement
Chapters
Table of Contents
Troubleshooting
