Carriage Motor Assy; Carriage Unit - Star Micronics LC-7211 Technical Manual

10. Carriage Motor Assy

11. Carriage Unit

(1) Remove
• Rear case unit as described in section 2.
• Screw [1]
• Spring [2]
Set tension lever assy [3] in the unlocked posi-
tion.
• Two screws [4]
• Carriage motor unit [5]
Note:
When assembling the carriage motor assy, the
tension lever assy [3] must be secured with the
screw [1] when the spring [2] is in place.
(1) Remove
• Ribbon holder as described in section 3.
• Print head as described in section 8.
• Head cable [1]
• Ground spring [2]
• Stop ring [3]
• Adjusting gear [4]
• Adjusting bushings L, R [5] [6]
Adjusting bushings L/R can be removed by turn-
ing them.
• Carriage unit [7]
Center the carriage unit.
Note:
Move the carriage unit to the center position, then
align the "∆" mark of adjusting gear [4] with the
"∆" mark of adjusting lever [8].
– 40 –