Oce Arizona 250 GT User Manual page 118

How to Print on Roll Media
[65]
[65] Roll Media Manager Keyboard
Note: If you have used a media before, it will be listed in the Media Type pull-down
menu. If the list contains less than 10 media types, a drop down list is displayed. If
there are more that 10 media types, they are displayed in a dialog with a scroll bar.
If you make any changes to the media name or parameters the advisory pane will
change color to indicate that there are unsaved changes and will display relevant
commands.
Select the Media Tension
6.
Note: The Media tension option allows you to choose the amount of force placed
onto the media shafts to keep it tightly drawn as it moves through the RMO unit. The
low tension setting is usually fine; however, if the media shows significant puckering
across its entire width, the medium or high tension setting may be required.
Select the Media Advance Correction Factor
7.
Note: Leave it at 50 unless you see light or dark lines of banding in the printed
image (refer to the next section "How to Set the Media Advance Correction Factor
for more details).
When the displayed media values are correctly matched to the loaded media, click
8.
Close to exit the Media Manager.
Click on the Roll icon in the menu bar of the Job Control module to activate the
9.
RMO print queue (the icon will change from yellow to green).
Result
Any print jobs that are in the queue, not on hold, and marked as roll jobs will print.
There is no explicit confirmation required to start a roll media print job. Any roll
media jobs in the print queue will start to print immediately.
118 Chapter 6 How to Operate the Roll Media Option