Oce Arizona 250 GT User Manual page 111

A: Load Media Roll On a Media Shaft And Install the Shaft in the Supply Position
Place an empty media shaft on a suitable flat work area, positioned as shown, so that
1.
the hex key is inserted on the right side of the shaft to lock and unlock the core locks.
[58]
[58] Unlock the Media Shaft Core Locks
Unlock the media shaft core locks (1) with the supplied 5mm hex key (2).
2.
Slide a new roll of media onto the supply shaft.
3.
Note: The default thread path for the supply media is referred to as "Print side out"
when the media unrolls from the bottom of the shaft towards the printer (see section
C "Thread the Media"). If you need to print with the "Print side in", you must
position the media so that it unrolls from the top of the shaft and also make sure the
correct icon is selected in the Roll Media Manager menu.
Roughly center the roll and then insert the shaft into the Supply (bottom) position on
4.
the printer.
Accurately center the media using the supplied ruler. Media should be centered
5.
within 1mm on the ruler.
Lock the supply media shaft core locks with the 5mm hex key.
6.
B: Load an Empty Core On a Media Shaft and Install the Shaft in the Take-up
Position
Place the empty take-up media shaft on a suitable work surface and unlock the media
1.
shaft locks with the 5mm hex key.
Slide an empty media core that is at least as long as the supply media width onto the
2.
take-up shaft.
Roughly center the core and then insert the shaft into the Take-up (top) position on
3.
the RMO unit.
Center the core using the supplied ruler so that the take-up media can be aligned to
4.
the supply media roll when it is later threaded.
Lock the take-up media shaft core locks with a 5 mm hex key.
5.
How to Load Media
111