Oce Arizona 250 GT User Manual page 168

How to Clean the Rubber Capstan
[83]
[83] Remove lint, dust, paper particles and debris
Removing Stains (coffee, tea, soda pop, etc.)
Supplies Needed: Rubber gloves, soap, hot water, and lint-free cloth.
Put on nitrile golves
1.
Mix a cleaning solution that is 50:1 hot water to soap.
2.
Note: Use a mild detergent such as Ivory - avoid soaps that have dies, moisturizing
oils, or perfumes as they may damage the capstan. Read the label! Our R&D Lab
has tested only Ivory Detergent. If you are uncertain about a detergent try it out in a
50:1 solution on a small area at the end of the capstan.
Wet the cloth in the cleaning solution and wring out excess liquid. Scrub the surface
3.
of the capstan using the cleaning cloth.
Allow adequate time for the capstan to dry.
4.
Note: If scrubbing action leaves debris on the surface, wait for the surface to dry
completely, then follow the procedure listed above for "Removing Solid Debris".
Removing Uncured Ink
Supplies needed: Rubber Gloves, Wrap-around safety goggles, Several absorbent
clothes, and Isopropyl Alcohol (95% pure).
Put on gloves and goggles.
1.
168 Chapter 10 Printer Maintenance