Special Prints Module - Oce Arizona 250 GT User Manual

Special Prints Module

Introduction
The Special Prints module consist of two lists. The list on the left displays available
special test prints. Most of these prints are used by service technicians to adjust and
troubleshoot the printer. There are some that is of interest to the Operator: the rulers
and the Nozzle Check Print a Nozzle Check. The rulers are meant to be printed on
the table to assist you to place media. These images are set up to print on the
horizontal and vertical axes of the table. They are available in metric or imperial
measure. The Nozzle Check is used to determine if there are any clogged nozzles
that can affect print quality (note that it is also available on the command toolbar in
the Print Job Control module).
The list on the right shows all active jobs that are currently in the print queue. Add a
print from the left into the right list to make it active in the Print Job Control module.
If you remove a job from this list, it is also removed from the Active job list and is
not available to print.
Illustration
[44]
[44] Special Prints Module
How to Load a Special Print
1) Click to select a test print in the left window
2) Click the Add button to place it in the print queue on the right.
The test print is now available in the Active job list.
Special Prints Module
67