Oce Arizona 250 GT User Manual page 116

How to Unload and Cut Media
The other option is remove the take-up roll from the printer and then remove the roll
2.
of unused media from the media shaft. To remove the take-up roll, tap the right pedal
momentarily to rotate the take-up shaft one revolution to the unlocked position in the
forward direction.
C: Remove the Supply Shaft From the Printer
If you want to change the supply shaft, momentarily press the left pedal to rotate the
1.
supply shaft four complete revolutions. This rewinds excess media back onto the
supply roll if is not empty) to the unlocked position.
Remove the supply shaft from the printer by pulling it up and out of the drive coupler.
2.
D: Remove Media Roll Or Empty Core From the Media Shaft
Place the media shaft on a suitable work surface.
1.
Unlock the media shaft core locks using a 5 mm hex key.
2.
Slide the media core off the shaft.
3.
Result
Roll Media unit is now ready for you to load new media.
116 Chapter 6 How to Operate the Roll Media Option