Oce Arizona 250 GT User Manual page 109

Component - function table
[35]
[35] Roll Media Manager Icons
Icon
Load
Unload
Initialize
Print Side
How to Use the Roll Media Manager
The procedure to use these icons to load and unload media is explained in the next
two sections. To verify or change media parameters and to actually print a roll media
job is explained in the section "How to Print on Roll Media".
Function
Allows the operator to load new media. Set the foot pedal
switches to the Load state.
Prepares the RMO to allow the operator to cut the existing
media, remove it, and replace it with a new roll.
Sets up tension on the loaded media and prepares the RMO to
print on that media.
Operator can select either Print Side In or Print Side Out.
Print Side In allows you to print on the back side of the media.
The default setting is Print Side Out.
Roll Media Manager
109