Oce Arizona 250 GT User Manual page 112

How to Load Media
C: Thread the Media
Select the Load icon from the Roll Media Manager.
1.
If you are going to print with "Print Side In", click the icon in the Roll Media
2.
manager ("Print Side Out" is the default so you do not need to select it unless you
have recently used Print Side In). Note that the icon toggles from one choice to the
other when you click it.
Note: For Print Side Out, the media comes out from under the supply shaft as shown
in green on the left below.
For Print Side In, the media comes out over the top of the supply shaft as shown in
red on the right. This allows you to print on the "back" side of the media.
[59]
[59] Media Path Choices
Wait for the gantry to move part way across the table.
3.
Continually press on the right foot pedal, as required, to gradually advance the media
4.
for the next two steps.
Thread the media under the media tension bar (Note that the media is threaded for
5.
Print Side Out in the photo below).
[60]
[60] Thread Media Under Tension Bar
Open the media access door at the top of the Roll Media unit, then reach down
6.
through the open door to grasp the media and feed it up and over the take-up roll.
112 Chapter 6 How to Operate the Roll Media Option