Oce Arizona 250 GT User Manual page 66

Settings Module
Printer Settings
[27]
[42]
[42] Printer Settings
Allows you to set the following:
Flatbed print gap
Underlay thickness
Table vacuum timeout
End of swath delay
Full carrage travel
Automatic warmup day
Automatic warmup time
Ionizer bar (static suppression - On or Off)
Roll Module
[28]
[43]
[43] Roll Media Settings
Separation Between Copies
Specifies the separation in the selected measurement units.
Media Move on Unload
Speifies the amount of media moved on unload in the selected measurement units.
Note: This setting icon is dislayed only if the Roll Media Option is installed.
66 Chapter 4 How to Navigate the User Interface