Oce Arizona 250 GT User Manual page 114

How to Load Media
Note: If the media is not aligned, it is possible to unlock the core locks and slide the
media core until it is centered and aligned.
Rewind the media by continually pressing down the left foot pedal until it is
8.
positioned where it can be taped to the take-up core.
Tape the media onto the core. The media should have a clean straight edge prior to
9.
taping. First tape the center of the media to the core, and then tape both ends of the
media.
[63]
[63] Tape Media to the Take-up Roll Core
Note: Ensure that the media is flat along the core. If the media is not flat it can
create an uneven roll that affects the motion of the media past the printheads and
therefore the quality of the image.
D: Initialize Roll Media To Prepare For Printing
Select the "Initialize" icon from the Roll Media Manager to properly tension the
media and to prepare for printing.
E: Select Existing Or Create New Media Parameters
From the Roll Media Manager select the media to be printed on or create a new set
of media parameters for the media loaded. Refer to the Roll Media Manager section
for details.
Result
You are now ready to print. Refer to the How to Print on Roll Media section for
instructions
114 Chapter 6 How to Operate the Roll Media Option