General Procedure For Using Stamp - Sharp MX-4100N Operation Manual

GENERAL PROCEDURE FOR USING STAMP

To select stamp settings, follow the steps below.
Place the original.
1
Place the original face up in the document feeder tray, or face down on the document glass.
Select the special modes.
(1) Touch the [Special Modes] key.
2
(2) Touch the
(3) Touch the [Stamp] key.
☞
Special modes menu (2nd screen)
Special Modes
Stamp
Date
Page
Numbering
Watermark
3
• "Date" and "Page Numbering" cannot be selected in multiple positions. If the [Date] key or [Page Numbering] key is
touched when "Date" or "Page Numbering" has already been selected for a position, a message will appear asking
you if you wish to move that item to the selected position. To move the item, touch the [Yes] key. Otherwise, press
the [No] key.
• If you attempt to set "Date", "Text", or "Page Numbering" in a position where one of these items is already set, a
message will appear. To change the previously selected item to the new item, touch the [Yes] key. To keep the
previous item, touch the [No] key.
Downloaded From ManualsPrinter.com Manuals
keys to switch through the screens.
(page 2-44)
Cancel
Stamp
Text
Layout
Select the print position.
OK
Select from 6 positions: top left, top centre, top right, bottom
OK
left, bottom centre, bottom right.
1
You can also skip this step and go directly to the next step. In
2
this case, the stamp items will be printed in the following
positions:
Date: Top right
Page number: Bottom centre
The position of a watermark cannot be selected. Proceed to the
next step.
Print positions
The keys that show the print positions will appear as follows
depending on the state of the settings.
The above key is the top left key. The appearance of each key
varies depending on the position of the key.
2-87
Stamp: Top left
Text: Top left
Not selected, stamp setting has not
been selected.
Selected during selection of the stamp
setting.
Not available, stamp setting has already
been allocated.
Contents
COPIER