Sharp MX-4100N Operation Manual page 450

Press the [BLACK & WHITE START] key.
Scanning begins.
• If you inserted the original pages in the document feeder tray, all pages are scanned.
A beep will sound to indicate that scanning is finished.
• If you are scanning the original on the document glass, scan each page one page at a time.
5
When scanning finishes, place the next original and press the [BLACK & WHITE START] key. Repeat until all pages have
been scanned and then touch the [Read-End] key.
A beep will sound to indicate that scanning is finished.
To cancel scanning...
Press the [STOP] key (
For a broadcast transmission, changes to the transaction report print conditions apply to all destinations.
To cancel the transaction report setting...
Touch the [Cancel] key in the screen of step 4.
• System Settings (Administrator): Transaction Report Print Select Setting
This is used to set the conditions for printing transaction reports.
The factory default setting is
Single Sending: Print Out All Report/
Broadcasting:
Receiving:
Confidential Reception (fax mode):
• System Settings (Administrator): Original Print on Transaction Report
This is used to have part of the transmitted original printed on the transaction report.
Downloaded From ManualsPrinter.com Manuals
) to cancel the operation.
.
Print Out Error Report Only
Print Out All Report
/Print Out Error Report Only/No Printed Report
Print Out All Report/Print Out Error Report Only/
Print Out Notice Page
/No Printed Report
No Printed Report
/No Printed Report
4-97
FACSIMILE
Contents