Sharp MX-4100N Operation Manual page 428

Fax/Special Modes
Erase
Edge Centre
Erase
Erase
Side Erase
4
Press the [BLACK & WHITE START] key.
Scanning begins.
• If you inserted the original pages in the document feeder tray, all pages are scanned.
A beep will sound to indicate that scanning is finished.
• If you are scanning the original on the document glass, scan each page one page at a time.
5
When scanning finishes, place the next original and press the [BLACK & WHITE START] key. Repeat until all pages have
been scanned and then touch the [Read-End] key.
A beep will sound to indicate that scanning is finished.
To cancel scanning...
Press the [STOP] key (
When the erase function is used, erase takes place at the edges of the original image. If you also use a reduction or an
enlargement setting, the erase width will change according to the selected ratio. For example, if the erase width setting is
20 mm (1") and the image is reduced to 50%, the erase width will be 10 mm (1/2").
To cancel an erase setting...
Touch the [Cancel] key in the screen of step 4.
System Settings (Administrator): Erase Width Adjustment
The default erase width setting is linked to the copy mode system setting, and can be set from 0 mm to 20 mm (0" to 1"). The
factory default setting is 10 mm (1/2").
Downloaded From ManualsPrinter.com Manuals
(1) (2)
Cancel
Edge+Centre
Edge
Erase
10
).
Select the erase settings.
(3)
(1) Touch the desired erase mode.
OK
Select one of the 4 erase modes.
OK
Touch the [Side Erase] key to open the following screen.
Erase
Side Erase
(0~20)
mm
Left
Touch the checkbox of the edge that you wish to erase
and make sure that a checkmark (
When performing two-sided scanning, set the erase edge
on the reverse side.
• If you touch the [Same Side as Side 1] key, the edge in
the same position as on the front side will be erased.
• If you touch the [Different Side from Side 1], the edge in
the position opposite to the erased edge on the front
side will be erased.
When you have completed the settings, touch the [OK]
key.
(2) Set the erasure width with the
0 mm to 20 mm (0" to 1") can be entered.
(3) Touch the [OK] key.
4-75
FACSIMILE
OK
Cancel
Erase position
Up
for Original Side 2
Right
Same Side as
Side 1
Different Side
from Side 1
Down
) appears.
keys.
Contents