Stacking Components; Compactflash Memory Card; Figure 2-4. Stack Mounting The Smartcontroller And Sdio - adept technology Adept RS-232/TERM User Manual

Chapter 2 - SmartController Installation

Stacking Components

To stack mount the SmartController and an sDIO or sMI6 module, install two brackets on
each side of the units, as shown in
and sMI6 modules.
120.9
28.1 16.0
30.7
76.5
186.5

Figure 2-4. Stack Mounting the SmartController and sDIO

CompactFlash Memory Card

The SmartController is equipped with a CompactFlash
system uses a CF in place of a traditional hard disk drive. In fact, it is often referred to as a
"solid state hard drive". The CF is about half the size of a credit card and twice as thick. It
has no moving parts and is therefore reliable and durable. It is also removable and can be
moved to another SmartController for replacement or testing.
The CF capacity shipped with all systems is currently 30 MB and is factory configured by
Adept. The CF stores the V
programs, data files and Adept licenses.
NOTE: Adept reserves the right to increase the size of the CF without
notice.
28
Figure 2-4. These brackets are supplied with the sDIO
2X 40356-00002
BOTH SIDES
8X M3 x 6MM
BOTH SIDES
133.0
+
operating system, optional AIM software, application
Adept SmartController User's Guide, Rev. E
328.9
IEEE-1394
1.1 1.2 X1 X2
R
LINK
OK SF
R
IEEE-1394
Device Net
Eth 10/100
SW1
OK HPE LAN 1.1 1.2
SF ES HD
1 2 3 4
ON
OFF
1 2 3
XDIO
XUSR
™
(CF). The SmartController
*S/N 3563-XXXXX*
X3 X4
XDC1 XDC2
24V 0.5A
-+ -+
*S/N 3561-XXXXX*
RS-232/TERM RS-422/485
XSYS XFP XMCP XDC1 XDC2
24V 5A
-+ -+