Table of Contents
Advertisement
Chapter 3 - SmartController Operation
executing program, or the MCP. Once this request has been made, the operator must press this
button and high power will be applied.
5. Emergency Stop Switch
The E-Stop is a dual-channel, passive E-Stop that supports Category 3 CE safety requirements.
It supports a customer-programmable E-Stop delay that maintains motor power for a
programmed time after the E-Stop is activated. This customizable feature allows the motors to
decelerate under servo control to a stop. This can aid in eliminating coasting or overshooting
on low friction mechanisms. It can also aid in the reduction of wear on highly geared, high
inertia mechanisms, while maintaining safety compliance per all standards.
NOTE: Instructions on configuring the E-Stop delay can be found within
the SPEC.V2 section of the
manual.
3.4
Configuring the Controller
The SmartController is shipped with the factory configuration described in the next
section. See
Figure 3-1 on page 37
changes to this configuration, set DIP switch SW1 as described below.
Factory Default Settings
Refer to row #5
Table 3-3
With this default DIP switch setting, the system will read the configuration data from the
CompactFlash. This allows you to set all the configuration options using the CONFIG_C
utility in software without changing the physical DIP switches. See the description of the
CONFIG_C program in the
further information.
DIP-Switch Settings
The following table shows the options for DIP switch SW1 on the SmartController.
42
Instructions for Adept Utility Programs
for the location of DIP switch SW1. If you need to make
for the factory default settings for DIP switch SW1.
Instructions for Adept Utility Programs
SW1
1 2 3 4
Adept SmartController User's Guide, Rev. E
documentation for
ON
OFF
Hide quick links:
Advertisement
Table of Contents
