Smartcontroller Operation; Smartcontroller Cs Connectors And Indicators; Figure 3-1. Smartcontroller Cs; Table 3-1. Smartcontroller Leds - adept technology Adept RS-232/TERM User Manual

SmartController Operation

3.1

SmartController CS Connectors and Indicators

R
SmartServo
OK HPE LAN SW1
1.1
SF ES HD
1 2 3 4
ON
OFF
1 2 3
XDIO
All the connectors on the SmartController use standard density spacing, D-subminiature
connectors. For customization purposes, the user needs to provide connectors of the
appropriate gender and pin count or use optional Adept cables.
NOTE: The SmartController CX has all of the connectors and indicators
described in this section for the SmartController CS, plus additional ones
covered in
1. Top Three Status LEDs
The top three two-color LEDs indicate diagnostic test, power control, and communication
status.
LED
OK/SF
HPE/ES
LAN/HD
During system bootup, the red OK/SF and HPE/ES LEDs are lit and the red LAN/HD LED
blinks. After system bootup, the OK/SF LED should show green. If the HPE/ES LED shows
red, the E-Stop circuit is open. During CompactFlash reads and writes, the LAN/HD LED
pulses red. When the controller is active on an Ethernet network, the LAN/HD LED pulses
green.
Device Net
Eth 10/100
1.2
XUSR

Figure 3-1. SmartController CS

Section 3.2 on page 40.

Table 3-1. SmartController LEDs

Green Indicates
System OK
High Power Enabled
Ethernet Access
Adept SmartController User's Guide, Rev. E
RS-232/TERM
XSYS XFP
Red Indicates
System Fault
E-Stop Open
Read/Write from
CompactFlash
3
*S/N 1000-XXXXX*
RS-422/485
XMCP
XDC1 XDC2
24V 5A
- + - +
37